National Instruments NI EDIDS-2400 Series, User Manual, Page: 38 / 314

38 | ni.com | NI EDIDS-2400 Series User Manual
3.2.5 Backing Up the DI Driver System Software Image
A DI Driver System software backup image can be created by following the instructions below. It is recommended
this procedure be performed after the system has been calibrated and ready for deployment.
*Note: The DI Driver System must be in static IP address mode for the backup to restore correctly. For more
information on changing your system to static IP mode see Changing The Network Settings Of The DI Driver
System .
1. Open the SCM console and select Backup Target from the File menu to open the Real-Time System Backup
dialog.
2. Select the
Backup Real-Time System
button to open the
Backup Target
dialog. Select the
Browse
button to
open the Select RT System dialog.
3. This will cause SCM to search the network for a National Instruments RT controller, such as the cRIO-9082.
Select the line associated with the system. Press OK to close the dialog and return to the Backup Target dialog.