National Instruments NI EDIDS-2400 Series, User Manual, Page: 26 / 314

26 | ni.com | NI EDIDS-2400 Series User Manual
3.2.3.2 Changing The Network
Settings Of The DI Driver System
This section assumes that a connection with the DI Driver System user interface is already established, and it is
desired to change the IP address. If a connection has never been established, please refer to Out Of The Box
Connection . If the IP address of the DI Driver System is unknown and a connection with the user interface cannot be
established, please refer to Setting the Controller Network Interface To DHCP .
1. After starting the system main user interface, double-click on the Execution Information window.
2.) After the
Execution Information
window opens, select the
Network
tab to make changes to the controller
network settings. The settings shown on this tab are similar to the Windows PC LAN TCP/IPv4 Properties dialog.
The image below shows an example of changing the controller IP address to 192.168.2.34.
The Default Gateway and DNS Server IP addresses may be important if the system is connected to a network
router. A network administrator should be contacted for this information. If a direct, "point-to-point" network
connection is made between the Windows PC and the system controller, both Default Gateway and DNS Server
addresses may be set to 0.0.0.0.