National Instruments NI EDIDS-2400 Series, User Manual, Page: 110 / 314

110 | ni.com | NI EDIDS-2400 Series User Manual
Tip Strip: Sets the requested throttle mode.
Detail: Requested operating mode for throttle Channel X.
IDLE : The throttle motor voltage is 0V. Primary Position is calculated according to Position Calibration Out
parameters.
POSITION CALIBRATION : This mode can only be entered when ModeStatus_ChX is IDLE. Starts the position
calibration process, guided by Position Cal Settings cluster parameters. This mode will remain and repeat until the
ModeRequest is changed. When ModeRequest is changed to IDLE, the ModeStatus will immediately change to
IDLE. When ModeRequest is changed to CONTROL, the ModeStatus will change to CONTROL upon completion of
the current position calibration process.
CONTROL CALIBRATION :
This mode can only be entered when ModeStatus_ChX is IDLE. Starts the control
calibration process, guided by Control Cal Settings cluster parameters. When the control calibration process is
complete, Mode Status returns to IDLE. This operating mode is not currently implemented and forces the Mode
Status back to IDLE.
CONTROL :
This mode can only be entered when ModeStatus_ChX is IDLE. This mode controls the throttle
position to the Position Setpoint input. This mode is exited only when Mode Request is set to IDLE. It is not
possible to move directly from this mode to a Position Calibration or Control Calibration mode.
ModeStatus_ChX
Tip Strip: Indicates the throttle mode status.
Detail: Status of operating mode for Channel X. See detail of ModeRequest_ChX for description of each operating
mode.
PrimaryPsnSwitch_ChX
Tip Strip: Indicates the Position Calibration currently in use for the Primary Position.
Detail: Determines which analog input within the Module Data cluster is the primary position sensor signal and which
is the secondary position sensor signal.