National Instruments NI DIDS-2103, User Manual

Page: 98 / 223

98 | ni.com | NI DIDS-2100 Series User Manual
Figure 4.5.2.b, Pulse Train for EOI Timing Mode. The reference timing is TDC position for each individual cylinder. Applicable to EPT
mode.
Duration
Tip Strip: Duration of injection pulse
Units: CAD
Detail: This parameter is always disabled, but automatically updated with a calculated value. It is calculated
based on Duration (msec) and engine speed shown in the EPT Tab of the Engine Position Tracking Setup
window.
DIX Timing Mode
Tip Strip: Selects timing mode of each injection pulse as Start Of Injection or End Of Injection
Detail: Selector for choosing between Start of Injection “SOI” Mode and End of Injection “EOI” Mode. When
SOI
mode is selected, the
EOI
Timing parameters will be disabled and retain their most recently entered end
of injection angle. When EOI mode is selected, the SOI Timing parameters will be disabled and retain their
most recently entered start of injection angle.
DIX Adv Settings
Tip Strip: Press this button to define duration for each Driver channel.
Detail: Pressing this button launches the DI1 Advanced Configuration control window. The DI1 Advanced
Configuration window allows a user to program individual injection pulse durations for each pulse in an
injection sequence.