National Instruments Direct Injector Driver System Manual
© 2013 National Instruments. All rights reserved.
4.7 Calibration Mode Setup Window
The purpose of the Calibration Mode Setup window is to configure a series of uniform injection command pulses
to the enabled channel of each DI Driver module. Only one channel of each DI Driver may be enabled at a time,
otherwise no commands will be delivered to a module with multiple channels enabled. This window is only applicable
when one or more DI Driver modules are configured for Calibration mode.
CalSeq Start
Tip Strip: Starts the specified pulse sequence
Detail: When pressed, starts delivering the number of injection command pulses specified by
according to the specified
and
CalSeq Pause
Tip Strip: Pauses calibration sequence