6
|
ni.com
|
NI CVS-1458RT Getting Started Guide
Installing the Vision Development Module
Install the following software to use the Vision Development Module to develop applications
and LabVIEW FPGA to reconfigure the I/O. The software must be installed in this order.
1.
LabVIEW
—Refer to the
LabVIEW Installation Guide
for installation instructions and
system requirements for the LabVIEW software. Refer to the
LabVIEW Upgrade Notes
for
additional information about upgrading to the most recent version of LabVIEW.
Documentation for LabVIEW is available by selecting
Start»All Programs»National
Instruments»LabVIEW
.
2.
LabVIEW Real-Time Module
—Refer to the
LabVIEW Real-Time Module Release and
Upgrade Notes
for installation instructions and information about getting started with the
LabVIEW Real-Time Module.
Documentation for the LabVIEW Real-Time Module is available by selecting
Start»
All Programs»National Instruments»LabVIEW
.
3.
LabVIEW FPGA Module
—It is only necessary to install the LabVIEW FPGA Module if
you want to reconfigure the default personality of the NI CVS-1458RT I/O. Refer to the
LabVIEW FPGA Module Release and Upgrade Notes
for installation instructions and
information about getting started with the LabVIEW FPGA Module.
Documentation for the LabVIEW FPGA Module is available by selecting
Start»
All Programs»National Instruments»LabVIEW
.
4.
NI Vision Development Module
—Refer to the
NI Vision Development Module Readme
on the NI Vision Development Module installation media for system requirements and
installation instructions.
Documentation for the NI Vision Development Module is available by selecting
Start»
All Programs»National Instruments»Vision»Documentation»NI Vision
.
5.
NI-IMAQdx
—Refer to the
NI Vision Acquisition Software Release Notes
on the NI Vision
Acquisition Software installation media for system requirements and installation
instructions for the NI-IMAQdx driver.
Documentation for the NI-IMAQdx driver software is available by selecting
Start»
All Programs»National Instruments»Vision»Documentation»NI-IMAQdx
.
6.
NI-IMAQ I/O
—NI-IMAQ I/O is required to use the default personality of the
NI CVS-1458RT in LabVIEW, or to reconfigure the default personality of the
NI CVS-1458RT I/O in the LabVIEW FPGA Module. Refer to the
NI Vision Acquisition
Software Release Notes
on the NI Vision Acquisition Software installation media for
system requirements and installation instructions for the NI-IMAQ I/O driver.
Documentation for the NI-IMAQ I/O driver software is available by selecting
Start»
All Programs»National Instruments»Vision»Documentation»NI-IMAQ I/O
.
NI-IMAQ and NI-IMAQdx integrate with Measurement & Automation Explorer (MAX), the
National Instruments utility for configuring and testing your measurement and automation
system. The NI MAX icon appears on your desktop after you install one of the device drivers.