© National Instruments
|
1-19
Mounting the cDAQ Chassis on a Panel
Panel or wall mounting is the best method for applications that are subject to high shock and
vibration. You can use the NI panel mount kit, part number 781919-01, to mount the cDAQ
chassis on a flat surface. Complete the following steps.
1.
Fasten the mounting plate to the chassis using a number 2 Phillips screwdriver and
six M4 × 10 screws. National Instruments provides these screws with the panel mount kit.
Tighten the screws to a maximum torque of 1.3 N ·
m (11.5 lb ·
in.).
Figure 1-13.
Installing the Mounting Plate on the cDAQ Chassis