![background image](http://html1.mh-extra.com/html/national-instruments/ni-can/ni-can_user-manual_3506864054.webp)
Chapter 5
NI-CAN Configuration Utility
©
National Instruments Corporation
5-3
Note
Because the current version of Windows NT is not fully Plug and Play, you must
specify valid hardware resources for the CAN interface using the Resources button before
using your National Instruments CAN interface with Windows NT. For information on
verifying proper resource assignment, refer to your NI-CAN getting started manual.
After you have finished configuring your CAN interfaces, click on the
OK
button to close the dialog box.
Configuring Objects with the NI-CAN Configuration
Utility
Settings
dialog box for an AT-CAN/2. The dialog
box shown is for Windows 98/95, but the Windows NT dialog box is
similar.
Figure 5-1.
NI-CAN Settings Dialog Box for an AT-CAN/2
Hardware information appears at the top of the dialog box, so you can
differentiate the selected CAN interface from others of the same type. For