![background image](http://html1.mh-extra.com/html/national-instruments/ni-6013/ni-6013_user-manual_3464287018.webp)
©
National Instruments Corporation
2-1
2
Installing and Configuring
the NI 6013/6014
This chapter explains how to install and configure the NI 6013/6014.
Installing the Software
Complete the following steps to install the software before installing the
NI 6013/6014.
1.
Install the ADE, such as LabVIEW, Measurement Studio, or
VI Logger, according to the instructions on the CD and the release
notes.
2.
Install NI-DAQ according to the instructions on the CD and the
DAQ Quick Start Guide
included with the NI 6013/6014.
Note
It is important to install NI-DAQ before installing the NI 6013/6014 to ensure that
the NI 6013/6014 is properly detected.
Installing the Hardware
The NI 6013/6014 fits in any PCI system slot in the computer. However, to
achieve best noise performance, leave as much room as possible between
the NI 6013/6014 and other devices.
The following are general installation instructions, but consult the
computer user manual or technical reference manual for specific
instructions and warnings.
Note
Follow the guidelines in the computer documentation for installing plug-in
hardware.
1.
Power off and unplug the computer.
2.
Remove the cover.