![background image](http://html1.mh-extra.com/html/national-instruments/ni-5731/ni-5731_user-manual_3533197003.webp)
NI 5731/5732/5733/5734R User Guide and Specifications
2
ni.com
Note
Before configuring your NI 5731/5732/5733/5734R, you must install the appropriate software
and hardware. Refer to the
NI FlexRIO FPGA Module Installation Guide and Specifications
for
installation instructions. Figure 1 shows an example of a properly connected NI FlexRIO device.
Figure 1.
NI FlexRIO Device
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits for electromagnetic
compatibility (EMC) as stated in the product specifications. These requirements and limits are designed
to provide reasonable protection against harmful interference when the product is operated in its
intended operational electromagnetic environment.
This product is intended for use in industrial locations. There is no guarantee that harmful interference
will not occur in a particular installation, when the product is connected to a test object, or if the product
is used in residential areas. To minimize the potential for the product to cause interference to radio and
television reception or to experience unacceptable performance degradation, install and use this product
in strict accordance with instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved by National
Instruments could void your authority to operate it under your local regulatory rules.
Caution
To ensure the specified EMC performance, you must install PXI EMC Filler Panels
(National Instruments part number 778700-01) in adjacent chassis slots. For more information about
installing PXI EMC filler panels in your system, refer to the
Appendix: Installing EMI Controls
section of this document.
Caution
To ensure the specified EMC performance, operate this product only with shielded cables
and accessories.
Caution
To ensure the specified EMC performance, install the included snap-on ferrite bead
(National Instruments part number 711856-01) on any cable attached to the AUX I/O connector in
accordance with the instructions listed in the
Appendix: Installing EMI Controls
section.
Caution
This product is sensitive to electrostatic discharge (ESD). To ensure the specified EMC
performance, follow the programming instructions listed at the end of the
and
Creating a LabVIEW Project and Running a VI on an FPGA
sections of this document.
NI FlexRIO
Adapter Module
+
=
NI FlexRIO Device
NI FlexRIO
FPGA Module
Summary of Contents for NI 5731
Page 1: ...NI 5732...