![background image](http://html.mh-extra.com/html/national-instruments/ni-177-series/ni-177-series_user-manual_709629029.webp)
Chapter 3
Connectors
NI 177x Smart Camera User Manual
3-4
ni.com
NI Smart Camera Power Requirements
Caution
Use the NI 177x Smart Camera only with a 12 W, 24 VDC ±10%, UL listed,
limited power source (LPS) supply. The power supply should bear the UL listed mark,
LPS. The power supply must meet any safety and compliance requirements for the country
of use.
The NI 177x Smart Camera uses a nominal 24 VDC power source. The
device accepts power within the range of 24 V ±10% with an additional
allowance for an AC peak of +5%. Refer to Appendix A,
, for
complete power requirement specifications.
100/1G Connector
The 100/1G connector is an 8-pin female connector that provides Ethernet
communication capabilities at 10 Mbit/sec, 100 Mbit/sec, or 1 Gbit/sec
(1000 Mbit/sec). The pinout of this connector follows the 100/1000 BaseT
Ethernet standard found in the IEEE 802.3-2002 standard.
Figure 3-3.
100/1G Connector
1
8
2
3
4
5
6
7