![background image](http://html1.mh-extra.com/html/national-instruments/mxi-vxi-pci8026/mxi-vxi-pci8026_getting-started_3476625026.webp)
Chapter 1
Introduction and Quick Start
1-12
www.ni.com
VXI/VME-MXI-2
This section summarizes the hardware and software default settings for the
VXI-MXI-2 and VME-MXI-2.
Table 1-5.
VXI-MXI-2 Hardware Default Settings
Hardware Component
Default Setting
Logical Address (U43)
1
VXIbus Slot 0/Non-Slot 0 (W2)
Automatic detection
VXIbus Local Bus (S8, S9)
Both OFF: Single VXI-MXI-2
VXIbus CLK10 Routing (W3)
From onboard oscillator
External Trigger Termination (S2)
OFF: Unterminated
SMB CLK10 Direction (S3)
OUT: Drive CLK10 signal
SMB CLK10 Termination (S4)
Ignored; effective only when S3
is set to IN.
Polarity of External SMB CLK10
(S5)
Inverted
MXIbus CLK10 Signal (S7)
Receive CLK10 from MXIbus
MXIbus Termination
(U35 switches 1 and 2)
Automatic MXIbus termination:
switch 2 set to YES; switch 1
ignored.
Configuration EEPROM
(U35 switches 3 and 4)
User-modifiable; factory settings
protected: both switches set to
NO.
DRAM SIMMs Installed
Per customer order
SIMM Size Configuration (S6)
OFF if SIMMS are 4 M
×
32
or larger; ON if smaller than
4 M
×
32.