Tools needed:
•
2.5 mm flat-blade screwdriver (your own or NI part number 786911-01)
•
19 mm deep socket or wrench
•
22 mm socket or wrench
•
27 mm deep socket
•
30 mm socket or wrench
•
24 mm socket or wrench
•
Ethernet termination tool
•
(Optional) 19 mm gland dome nut tightening tool (SEALCON part number S-1900-WR)
•
(Optional) 24 mm gland dome nut tightening tool (SEALCON part number S-2400-WR)
Safety
Caution
Observe all instructions and cautions in the user documentation. Using
the model in a manner not specified can damage the model and compromise the
built-in safety protection. Return damaged models to NI for repair.
Attention
Suivez toutes les instructions et respectez toutes les mises en garde de la
documentation utilisateur. L'utilisation d'un modèle de toute autre façon que celle
spécifiée risque de l'endommager et de compromettre la protection de sécurité
intégrée. Renvoyez les modèles endommagés à NI pour réparation.
Caution
The protection provided by the MON-10496 can be impaired if it is used
in a manner not described in the user documentation.
Attention
La protection apportée par le MON-10496 risque d'être endommagée s'il
est utilisé d'une autre façon que celle décrite dans la documentation utilisateur.
Caution
An external circuit breaker box must be installed according to applicable
electrical codes by trained personnel to serve as the power disconnect when
installing the MON-10496. The circuit breaker box must be easy to reach and
marked as the power disconnect for the device.
Attention
Un boîtier de disjoncteur externe doit être installé, conformément au
code électrique applicable, par du personnel qualifié pour servir de dispositif de
coupure de courant lors de l'installation du MON-10496. Le boîtier du disjoncteur
doit être facilement accessible et marqué en tant que dispositif de coupure de courant
pour l'appareil.
Caution
Before opening the MON-10496 for service, you must turn off the
external power to the device and use the external breaker box to completely remove
mains power.
4
|
ni.com
|
MON-10496 User Guide