Unpacking
Notice
Electrostatic Discharge (ESD) can damage the device. To prevent damage,
use industry-standard ESD prevention measures during unpacking, installation,
maintenance, and operation.
Notice
Never touch exposed signal terminals, power terminals, or antenna
connector.
Remove the device from the package and inspect it for loose components or any other signs of
damage. Notify NI if the device appears damaged in any way. Do not install a damaged
device.
Kit Contents
Kit Contents
1
2
3
4
5
6
1. MON-10496
2. MON-10496 Safety, Environmental, and
Regulatory Information
3. NI Monitoring Devices Card
4. 1 Antenna with weather-protective boot
5. 1 M16 Gland
6. 1 PG16 Gland
What You Need to Get Started
Hardware needed:
•
M6 to M8 bolts and nuts or 1/4 in. to 5/16 in. bolts and nuts
•
Washers (recommended)
•
M16 gland (supplied by NI)
•
PG16 gland (supplied by NI) or 0.5 in. conduit fitting
•
2 mm to 8 mm diameter CAT5e Ethernet cable with a smooth, round jacket
•
5 mm to 9 mm diameter power cable with a smooth, round jacket and individual
conductors up to 12 AWG that comply with your local electrical code
•
RJ45 connector
MON-10496 User Guide
|
© National Instruments
|
3