©
National Instruments Corporation
C-1
C
Removing the SCXI-1125
This appendix explains how to remove the SCXI-1125 from MAX and an
SCXI chassis.
Note
Figure C-1 shows an SCXI chassis, but the same steps are applicable to a PXI/SCXI
combination chassis.
Removing the SCXI-1125 from MAX
To remove a module from MAX, complete the following steps after
launching MAX:
1.
Expand
Devices and Interfaces
to display the list of installed devices
and interfaces.
2.
Expand
NI-DAQmx
Devices
and/or
Traditional NI-DAQ Devices
to
display the chassis.
3.
Expand the appropriate chassis to display the installed modules.
4.
Right-click the module or chassis you want to delete and click
Delete
.
5.
You are presented with a confirmation window. Click
Yes
to continue
deleting the module or chassis or
No
to cancel this action.
Note
Deleting the SCXI chassis deletes all modules in the chassis. All configuration
information for these modules is also deleted.
The SCXI chassis and/or SCXI module(s) should now be removed from the
list of installed devices in MAX.
Removing the SCXI-1125 from a Chassis
Consult the documentation for the chassis and accessories for additional
instructions and precautions. To remove the SCXI-1125 module from an
chassis, complete the following steps while referring to Figure C-1:
1.
Power off the chassis. Do
not
remove the SCXI-1125 module from a
chassis that is powered on.