SCC Quick Start Guide
22
ni.com
Step 7. Launch Measurement & Automation
Explorer (MAX)
Double-click the
Measurement & Automation
icon on the desktop to
open MAX.
Step 8. Configure the SC-2345/2350
You can use the SC-2350 only in NI-DAQmx 7.2 or later; you can use the
SC-2345 in either NI-DAQmx 7.0 or later or Traditional NI-DAQ.
1.
Open
Devices and Interfaces
. If your device does not automatically
appear, press <F5> to refresh the view in MAX. If the device is still not
recognized, refer to
ni.com/support/install
for troubleshooting
information.
2.
Right-click
Devices and Interfaces
and select
Create New
.
Figure 19.
Create New in Devices and Interfaces
3.
Select either the SC-2345 or SC-2350 from the Create New window.
4.
Select the carrier under
NI-DAQmx Device»NI-DAQmx
SCC Connector Block
. The configuration window opens as shown in
Figures 19 and 20.
