7-4
|
ni.com
Chapter 7
Ethernet Ports
Subnet Considerations
To configure the NI Smart Camera, it must reside on the same subnet as the development
computer. If you want to use the smart camera
on a subnet other than the one the development
computer is on, first connect and configure the smart camera on the same subnet as the
host computer.
The first time you configure the smart camera, you must also install software on it. After
configuring the smart camera, use DHCP to assign an IP address or reassign a static IP address
for the subnet where you want the smart camera to reside, then physically move the smart camera
to the other subnet. Refer to
Getting Started with the NI 17xx Smart Camera
for more
information about configuring the smart camera.
Contact your network administrator if you need assistance configuring the host computer and
smart camera on the same subnet.
7750
TCP
Used for NI-IMAQ remote configuration (not reserved).
3363
TCP/UDP
Reserved as nati-vi-server (NATI VI Server). Used by Vision
Builder for Automated Inspection to configure a remote NI Smart
Camera.
Table 7-2.
TCP/UDP Ports Used by the NI Smart Camera (Continued)
Port
Type
Details
Summary of Contents for ISC-1762
Page 1: ...ISC 1762...
