2-2
|
ni.com
Chapter 2
Power and I/O
NI Smart Camera Power Requirements
Caution
Use the NI Smart Camera only with a 24 VDC, UL listed, limited power
source (LPS) supply. The power supply should bear the UL listed mark, LPS. The
power supply
must
meet any safety and compliance requirements for the country
of use.
The smart camera uses a nominal 24 VDC power source. The smart camera accepts power within
the range of the industry standard IEC 1311 input power specification (24 V +20%/-15% with
an additional allowance for an AC peak of +5%). Refer to Appendix A,
, for
complete power requirement specifications.
Caution
The 24 V external lighting strobe is an unregulated output dependent on
the range of the power supply provided to the smart camera. If the power provided to
the smart camera is +20%/-15% with +5% AC ripple, the external lighting strobe
output could be as high as 30 V. If the provided power exceeds the input voltage
specifications of the third-party lighting controller, do
not
connect the 24 V lighting
strobe output to the controller to prevent damage to the controller. Use a power
supply with tolerances that meet the requirements of the controller, or use the 5 V
external lighting strobe.
TrigIn-
IsoIn(0)-
IsoIn(1)-
12
Light Green
IsoOut(0)+
6
Yellow
IsoOut(0)-
1
Green
IsoOut(1)+
11
Light Blue
IsoOut(1)-
7
Gray
3
Blue
PhaseA-
13
Brown/White
9
Purple
PhaseB-
4
White
Table 2-1.
POWER-I/O Connector Signal Descriptions (Continued)
Connector Diagram
Signal Name
Pin Number
Wire Color
5 (+24 V)
15 (COM)
11
6
1
10
Summary of Contents for ISC-1762
Page 1: ...ISC 1762...