Chapter 4
Nonvolatile Configuration
4-6
ni.com
device-dependent use. Region 1 always starts at local address 10000h.
The minimum size is 60000h. The maximum size is the amount of RAM
minus 10000h.
Number of pSOS Processes
You can use this parameter to configure the maximum allowable number
of pSOS processes. The GPIB-VXI/C requires a minimum of 16 processes.
The factory setting is 32.
Number of pSOS Message Exchanges
You can use this parameter to configure the maximum allowable number
of pSOS message exchanges. The GPIB-VXI/C requires a minimum of
16 message exchanges. The factory setting is 32.
Number of pSOS Message Buffers
You can use this parameter to configure the maximum allowable number
of pSOS message buffers. The GPIB-VXI/C requires a minimum of 100h
message buffers. The factory setting is 180h.
Console
You can use this parameter to set the GPIB-VXI/C RS-232 local command
console to default to enabled or disabled. You can use the local command
ConsoleEna
to change the setting at runtime.
Resource Manager Wait Period
You can use this parameter to specify how many seconds the Resource
Manager waits for devices to boot before starting setup of the VXI system.
VXI Interrupt Level to Handler Logical Address
This is a table of logical addresses the Resource Manager can use during
resource management of the VXI interrupt lines. If an interrupter is
hard-configured (not a VXI programmable interrupter), place the logical
address of the interrupt handler device in the corresponding level. If an
interrupt handler is hard-configured (not a VXI programmable handler),
place its logical address in the corresponding level to avoid conflicts with
other programmable handlers and also to permit the Resource Manager to
assign programmable interrupters to the correct levels. If all interrupters
and interrupt handlers are programmable, you can keep the value of
FFh
for
all entries in the table.
