Follow these guidelines to prevent interference with the C Series modules when transmitting
data wireless.
•
When mounting the cRIO-9032 inside an enclosure, use RP-SMA (male) to RP-SMA
(female) extension cables to route antennas outside of enclosure.
•
Do not route C Series module cabling near either antenna.
•
Do not position the antennas in an orientation that crosses the antenna keepout shown in
the following figure.
Figure 3. Antenna Keepout
Antenna
Keepout
Note
NI recommends connecting both antennas for the optimal wireless
performance and reliability.
Caution
In regions governed by the FCC and ETSI, only those antennas tested
with the device or similar antennas with equal or lesser gain may be used with this
transmitter. Depending on the regulatory region or country, alternate antennas may
not be covered by National Instruments transmitter certifications of the cRIO-9032.
NI recommends using only antennas provided with the cRIO-9032.
The following accessory is available as a replacement for the antennas provided by NI.
Table 16. Replacement Accessories
Antenna
Part Number
Additional Wireless Antennas (x2)
784818-01
Buttons
The cRIO-9032 provides the following buttons.
NI cRIO-9032 User Manual
|
© National Instruments
|
15