4-8
|
ni.com
Chapter 4
Digital Input/Output and PFI
Change Detection Event
The Change Detection Event is the signal generated when a change on the rising or falling edge
lines is detected by the change detection task.
Routing Change Detection Event to an Output Terminal
You can route ChangeDetectionEvent to any output PFI terminal.
Change Detection Acquisition
You can configure lines on parallel digital modules to detect rising or falling edges. When one
or more of these lines sees the edge specified for that line, the cDAQ chassis samples all the lines
in the task. The rising and falling edge lines do not necessarily have to be in the task.
Change detection acquisitions can be buffered or nonbuffered:
•
Nonbuffered Change Detection Acquisition
—In a nonbuffered acquisition, data is
transferred from the cDAQ chassis directly to a PC buffer.
•
Buffered Change Detection Acquisition
—A buffer is a temporary storage in computer
memory for acquired samples. In a buffered acquisition, data is stored in the cDAQ chassis
onboard FIFO then transferred to a PC buffer. Buffered acquisitions typically allow for
much faster transfer rates than nonbuffered acquisitions because data accumulates and is
transferred in blocks, rather than one sample at a time.
Digital Output
To generate digital output, insert a digital output C Series module in any slot on the cDAQ
chassis. The generation specifications, such as the number of channels, channel configuration,
update rate, and output range, are determined by the type of C Series module used. For more
information, refer to the documentation included with your C Series module(s).
With parallel digital output modules (formerly known as hardware-timed modules), you can do
multiple software-timed tasks on a single module, as well as mix hardware-timed and
software-timed digital output tasks on a single module. On serial digital output modules
(formerly known as static digital output modules), you cannot mix hardware-timed and
software-timed tasks, but you can run multiple software-timed tasks.
You may have a hardware-timed task or a software-timed task include channels from multiple
modules, but a hardware-timed task may not include a mix of channels from both parallel and
serial modules.
