Installing the ATCA-3671 Module
Caution
Install the RTM before installing the ATCA-3671. Installing the
ATCA-3671 before installing the RTM can damage the connectors of both modules.
1.
Ensure that the module ejector handles are in the open position, as shown in the following
figure.
Figure 2. Opening the Module Ejector Handles
ESD
SENSITIVE
ATCA-3671
FPGA Module for ATCA
AIO A
AIO B
AIO C
AIO D
JC OUT A
CLK IN/OUT A
JC OUT B
CLK IN/OUT B
1Gb ETH
GPIO B
AIO CLK
JTAG
SYNC A
GPIO C
MGT REF
SYNC B
GPIO D
GPIO A
JC OUT C
CLK IN/OUT C
JC OUT D
CLK IN/OUT D
2.
Gently guide the module into the chassis module guides and slide the module into the
chassis until it is fully inserted.
3.
Close the module ejector handles to fully seat the module and latch it to the chassis, as
shown in the following figure.
Figure 3. Closing the Module Ejector Handles
ESD
SENSITIVE
ATCA-3671
FPGA Module for ATCA
AIO A
AIO B
AIO C
AIO D
JC OUT A
CLK IN/OUT A
JC OUT B
CLK IN/OUT B
1Gb ETH
GPIO B
AIO CLK
JTAG
SYNC A
GPIO C
MGT REF
SYNC B
GPIO D
GPIO A
JC OUT C
CLK IN/OUT C
JC OUT D
CLK IN/OUT D
4.
Tighten the four captive screws on the panel to secure the module.
Installing AIO-3681/3682 Modules
Install one or more AIO-3681/3682 modules to enable analog-to-digital and digital-to-analog
conversion of RF signals.
Determine how many modules you are installing and choose the appropriate number of empty
slot(s) in the ATCA-3671. If hardware is present in the slot(s) you choose, remove the installed
ATCA I/O module(s), riser card(s), and additional components from the slot(s).
Ensure you have the following components for each AIO-3681/3682 module:
ATCA-3671 Getting Started Guide
|
© National Instruments
|
7