![background image](http://html1.mh-extra.com/html/national-instruments/7340/7340_user-manual_709123013.webp)
©
National Instruments Corporation
2-1
2
Configuration and Installation
This chapter describes how to configure and install the PXI/PCI-7340.
Software Installation
Before installing the 7340, install the NI-Motion driver software. Refer to
the
Getting Started with NI Motion Control
manual, which is included with
the controller, for specific installation instructions.
Note
If you do not install the NI-Motion driver software before attempting to use the
7340, the system does not recognize the 7340 and you are unable to configure or use the
device.
Controller Configuration
Because motion I/O-related configuration of the 7340 is performed entirely
with software, it is not necessary to set jumpers for motion I/O
configuration.
The PXI-7340 and PCI-7340 controllers are fully compatible with the
industry standard
PXI Specification
, Revision 2.0 and the
PCI Local Bus
Specification
, Revision 2.2, respectively. This compatibility allows the PXI
or PCI system to automatically perform all bus-related configuration and
requires no user interaction. It is not necessary to configure jumpers for
bus-related configuration, including setting the device base memory and
interrupt channel.
Safety Information
Caution
The following paragraphs contain important safety information you
must
follow
when installing and operating the 7340 and all devices connecting to the 7340.
Do
not
operate the device in a manner not specified in the documentation.
Misuse of the device may result in a hazard and may compromise the safety
protection built into the device. If the device is damaged, turn it off and do