Figure 3.
Installing the NI FlexRIO Adapter Module
PXI-1000B
1
4
3
2
5
1. NI FlexRIO Adapter Module
2. Captive Screw
3. Guide Pin
4. PXI/PXI Express Chassis
5. NI FlexRIO FPGA Module
The connection may be tight, but do not force the adapter module into place.
2.
Tighten the captive screws on the NI FlexRIO adapter module to secure it to the
NI FlexRIO FPGA module. NI recommends using the laser-tipped screwdriver (part
number 748677-01) included in the NI 5741 packaging.
3.
Launch LabVIEW to begin configuring your NI FlexRIO system.
Connecting Cables
•
Use any shielded50 Ω SMA cable to connect signals to the connectors on the front panel
of your NI 5741
•
Use the SHH19-H19-AUX cable (NI part number: 152629-01 or 152629-02) to connect
to the digital I/O (DIO) and programmable function interface (PFI) signals on the AUX
I/O connector. NI recommends using the SCB-19 connector block to access the DIO and
PFI signals.
•
Use the NI SHC68-C68-D4 VHDCI cable (NI part number: 196275-01) to connect to the
AO 0-15 connector.
NI 5741 Getting Started Guide
|
© National Instruments
|
7
