37 / 52
Assembly on a vertical or horizontal tube
5. Repeat steps 1 to 4 as before.
6. Place the assembly base with its bottom site first on the tube. Push the tube bracket against the
tube from the opposite site.
7. Slide 4 screws through the bore holes of the assemby base and through the bore holes of the tube
bracket on the other site.
8. Put on the 4 nuts and tighten the screw connection by hand.
14 Signal transmission
The base station will automatically connect to the outdoor sensor. If the battery is changed, the con-
nection must be made manually by pressing the [SENSOR] button and then pressing the [RESET]
button with a pointed object to manually search for the sensor. When the connection is successful, the
sensor signal strength indicator will be shown on the display.
Connection status display:
Connection status
Screen display
Good signal
Reception symbol
Searching for a sensor
Reception symbol flashes
No signal for 48 hours
Er' (Error) is shown
Sensor low battery status, good signal
Battery symbol is shown
15 Automatic time setting
After the power is restored, the unit automatically searches for the radio signal. It takes approximately
3-8 minutes for this process to complete.
If the radio signal is received correctly, the date and time are set automatically and the reception sym-
bol is displayed.
NOTICE! During radio signal reception, the backlight is set to dimmed mode and returned to
normal mode when signal reception is complete.
If no radio signal is received, proceed as follows:
1. Press the RCC button on the base unit for approx. 8 seconds to deactivate reception of the radio
signal (the display shows "OFF").
2. Press the RCC button on the base unit for approx. 8 seconds to activate reception of the radio sig-
nal ("ON" appears in the display). Reception is now initialised again.
3. If no radio signal is still received, the time setting must be made manually.
16 Manual time setting
To set the time/date manually, first disable the reception of the time signal by pressing the RCC button
for about 8 seconds.
1. Press the CLOCK-SET button for approx. 3 seconds to enter the time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press the CLOCK-SET button to confirm the entry and move to the next setting.
5. Settings order: 12/24-hour mode > Hours > Minutes > Seconds > Year > M> Day > Time offset >
Language > Daylight saving time Auto/off
6. Finally, press the CLOCK-SET button to save the settings and exit the setting mode.