National Crane 600H, Service Manual

Page: 210 / 232

CRANE INSTALLATION 600H SERVICE
9-28
08-19-2022 Control # 092-13
Attach the RSOD
1. Position the RSOD on the truck frame so that there is
about 12 in (30.4 cm) between the rear tire to the front of
t h e R S O D F i g u r e 9 -11 . T h i s s h o u l d b e e n o u g h
clearance for mounting the mud flaps.
2. Check for interference with truck frame rivets or bolt
holes.
3. Make sure that the RSOD jack is vertical and the foot is
11 in (27.9 cm) above the ground.
4. Use the RSOD brackets as a template and drill six 3/4 in
holes in the truck frame for each bracket.
5. Bolt the RSOD brackets to the truck frame with the 3/4 x
2-1/2 in grade 8 bolts. Torque, refer to
Fasteners and
Torque Values , page 1-7. Clamp the anchor bars to the
RSOD mounting bracket.
6. Use the holes in the brackets as a template and drill
three 5/8 in holes in each anchor bar.
7. Loosely bolt the anchor bars to the RSOD mounting
bracket.
8. Clamp the upper brackets to the anchor bars.
9. Position the upper brackets on the T-box and tack weld
in place.
10. Drill three holes in the anchor bar using the upper
bracket holes as a template.
11. Remove the anchor bars and weld the upper brackets
and gussets in place.
12. Bolt the anchor bars to the RSOD brackets and upper
brackets with the 5/8 in grade 8 mounting bolts; refer to
Fasteners and Torque Values , page 1-7 for proper
torque value.
Rear Outrigger Solenoid
Front Outrigger Solenoid
Driver Side
Beam Out
Passenger Side
Beam Out
Beams Out
Jacks Down
Driver Side
Jack Down
Passenger Side
Jack Down
600H BC Outrigger Solenoids
Passenger Side
Jack Down
Driver Side
Jack Down
Passenger Side
Beam Out
Driver Side
Beam Out
Beams Out
Jacks
Down
FIGURE 9-9
FRONT
FRONT
Passenger Side
Beam Out
Driver Side
Beam Out
Beams Out
Driver Side
Jack Down
Passenger Side
Jack Down
Jacks
Down
600H TM Front Outrigger Solenoid
FIGURE 9-10
FRONT
NOTE: The solenoid is
mounted inside the turret.
REFERENCE ONLY