NARDA SRM-3006, Operating Manual

Page: 89 / 240

6 Functions Common to More Than One Operating Mode
Narda SRM-3006
77
6.4.2 Reset measurement values
You can reset the values for Max, MxA, Avg, MnA, and Min:
6.5 The Marker function
Spectrum • Marker
The Marker function is very useful for marking and comparing specific
individual frequencies in the display. The following types of marker function
can be selected:
• Two independent markers.
• Individual display of each marker or display of the difference between the
markers.
• Automatic location of the highest peak value.
• Automatic location of the next peak values.
Note:
The markers allow access to all measured values, e.g. to every
spectral line measured. The spacing between two measured values
(two spectral lines) is approximately half the currently selected
resolution bandwidth.
Tip:
Turning the rotary control slowly causes the marker to jump in small
frequency steps. Turning the control faster causes larger frequency
jumps. Briefly turning the control in the opposite direction stops the
marker movement.
• Reset All: Resets all the above-mentioned measurement
values.
• Reset Min & Max: Resets the
Minimum (Min)
and
Maximum (Max)
measurement values only.