NARDA IDA, Operating Manual, Page: 224 / 292

12 Multi - Channel Power Mode
216
IDA - 3106 Narda
Changing the table type
The table below shows the measured values that are displayed depending
on the table type and the selected trace types.
NOTE:
All the measurements for channels with the same name (e.g. Vodafone or
T-Mobile) are combined together in the
Condensed
table type.
To change the table type:
1.
Press the
Display
softkey.
2.
Press the
Table
softkey until the desired table type is shown.
3.
Press the
ESC
key to return to the measurement menu.
Changing the displayed units
1.
Press the
Display
softkey.
2.
Press the
Unit
softkey.
3.
Use the rotary control knob to select the desired sort order and press the
OK
key.
4.
Press the
ESC
key to return to the measurement menu.
Table 38: Table type Condensed
Index Channel Trace types, e.g. Max
These columns are
displayed continuously.
A maximum of three trace types can be displayed.
If more than three trace types have been selected,
you can use the keys to scroll through all of
the trace types. Arrow symbols in the navigation bar
indicate that further trace types are available and the
possible scrolling direction.
Table 39: Table type
Detailed
Index Channel Fmin,
Fmax
RBW Trace types, e.g. Max
These columns are
displayed continuously.
RBW is only displayed
if the resolution
bandwidth is selected
individually using the
PC software (Others =
Off). If this is not done,
the RBW is shown
only in the lower
status bar.
Only one trace type can be
displayed.
If more than one trace type
has been selected, you can
use the keys to scroll
through all of the trace
types. Arrow symbols in the
navigation bar indicate that
further trace types are
available and the possible
scrolling direction.