7
W415-0788 / 05.15.09
1.5 CARE OF GLASS
5.1
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean the glass after
the fi rst 10 hours of operation with a recommended fi replace
glass cleaner. Thereafter clean as required. If the glass is not
kept clean permanent discoloration and / or blemishes may
result.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING
1.6 SHIPPING
BRACKET
SHIPPING BRACKET REMOVAL
A.
Remove the four screws holding the shipping bracket to the bot-
tom of the appliance.
B.
Lift the appliance off the skid and set on a fl at surface.
C.
Discard the screws, brackets and skid.
GLASS DOOR REMOVAL
A.
Lift the top casting off.
B.
Open the valve control cover. Pull the latch handles forward to
release. The door may now be safely removed by swinging the
bottom out and lifting it off.
SHIPPING BRACKET
GDS60: TOP VENT / REAR VENT VERTICAL TERMINATION:
Maximum input is 35,000 BTU/hr for natural gas and 31,500 BTU/hr for propane. Maximum output for natural
gas is 27,300 BTU/hr at an effi ciency of 78%. Maximum output for propane is 24,570 BTU/hr at an effi ciency of
78%. Maximum A.F.U.E. (Annual Fuel Utilization Effi ciency) rating is 72% for natural gas and 71% for propane.
REAR VENT HORIZONTAL TERMINATION:
Maximum input is 21,000 BTU/hr for natural and propane gas. This application requires changing the main
burner orifi ce.
This appliance is not approved for closet or recessed installations. It is approved for bathroom, bedroom and
bedsitting room installations.
This appliance may be installed in an aftermarket permanently located, manufactured (mobile) home, where
not prohibited by local codes.
GS60:
Maximum input is 35,000 BTU/hr for natural gas and 31,500 BTU/hr for propane. This appliance is approved
for bedroom and bed-sitting room installations.
LATCH
!
WARNING
THE TOP CASTING IS NOT FASTENED TO THE STOVE ASSEMBLY. IT SIMPLY SITS ON THE STOVE
AS A LID. FOR SHIPPING PURPOSES IT IS HELD IN PLACE BY PLASTIC STRAPPING. ONCE THE
STRAPPING IS CUT, THE TOP SHOULD BE LIFTED OFF CAREFULLY AND STORED IN A SAFE PLACE
TO AVOID DAMAGE WHILE COMPLETING THE INSTALLATION OF THE STOVE. TO AVOID THE APPLI-
ANCE BEING DAMAGED DURING SHIPPING, A SHIPPING BRACKET HAS BEEN USED AND MUST BE
UNBOLTED BEFORE THE APPLIANCE CAN BE INSTALLED.
NorthlineExpress.com
http://www.northlineexpress.com
Toll-Free 1-866-667-8454
