9
W415-0682 / D / 02.06.12
1.5 RESTRICTOR PLATE INSTALLATION
1.6 WIRING DIAGRAM AND INSTALLATION
Connect the wiring to the power vent termination as outlined in the previous section, and connect the wiring
to the appliance as outlined in the schematic below. Ensure that the proper clearances are maintained for the
wiring and conduit. When installing the wiring it must never run above the vent run and it must be a minimum 1”
from all venting.
NOTE: The GPV includes a 20 foot wire harness. If this harness does not reach the appliance, then it
may be cut and a splice added. These connections must conform with local codes or, in the absence
of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70
National Electrical Code in the United States.
REFER TO PVA KIT FOR APPLIANCE SPECIFIC INSTRUCTIONS.
1.6.1 SIT IPI 885 PROFLAME COMPLETE WITH GPV POWER VENT TERMINAL
1. Disconnect the wires labeled ON/OFF (White/Green) and TH (Green). Reconnect them to the
corresponding male/female connectors on the Power vent control module.
2. Disconnect the two D/C (Red/Black) wires from each other and reconnect them to the corresponding D/C
connectors on the Power vent control module.
3. Disconnect the Orange wire from the gas valve and reconnect it to the Yellow wire (female connector) from
the Power vent control module.
4. Connect the remaining Yellow wire (male connector) from the Power vent control module to the tab on the
gas valve where the Orange wire was removed.