5
W415-0682 / D / 02.06.12
1.3 VENT
LENGTHS
REFER TO POWER VENT ADAPTER KIT (PVA) FOR SPECIFIC VENTING INSTRUCTIONS.
NOTE: If equipped, ACS switch must be disabled if there is any downward venting. Downward venting is not
allowed with appliances that use standing pilots.
1.4 POWER VENT TERMINAL
1.4.1 TERMINAL INSTALLATION
20.4
A.
Remove the electrical access plate from the frame assembly, then remove the
knock out from this plate.
B.
Insert the wiring through the electrical access plate and engage the conduit bush-
ing. Re-secure this plate.
NOTE: The GPV includes a 20 foot wire
harness cable. If this cable does not reach the appliance, then it
may be cut and a splice added.
These connections must conform
with local codes or, in the absence of local codes, use the current CSA
C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70
National Electrical Code in the United States.
C.
Remove terminal access cover, see “INSTALLATION OVERVIEW” for
location and route cable through terminal.
D.
Assemble gas power vent terminal to frame assembly.
E.
Connect the male and female connectors.
F.
Replace terminal access cover.
NOTE: Where possible, it is strongly recommended to have an access panel inside the building for
servicing the unit.
This application occurs when venting through an exterior wall. Having determined the correct
height for the terminal location, cut and frame a hole in the exterior wall as illustrated to ac-
commodate the GPV.
DETERMINE
THE
CORRECT
HEIGHT
11 1/4”
10 1/4”
ELECTRICAL
ACCESS PLATE
TERMINAL
FEMALE
MOLEX
CONNECTOR
MALE MOLEX
CONNECTOR
