W415-0656 / C / 10.19.11
:ROI6WHHO/WG1DSROHRQ5G%DUULH21/0*&DQDGD ID[ ZZZQDSROHRQILUHSODFHVFRP
AK8 AND GICSK
INSTALLATION INSTRUCTIONS
FOR MODEL NPI-40
Included in the AK8 kit:
ITEM #
PART#
DESCRIPTION
QTY
1
W263-0096
Top
Flashing
1
2
W263-0098
Left
Flashing
1
3
W263-0097
Right
Flashing
1
4
W385-0334
Napoleon
Logo
1
W570-0001
Screw, #8 x 3/8"
2
W570-0006
Screw, #8 x 1/2"
4
W570-0020
Screw, #8-32 x 3/8"
4
W735-0026
Lock Washer, #8
4
W450-0008
Nut, #8-32 Hex
4
1.
Secure the
Right Flashing
to the right side of the unit using two
of the
#8 x 1/2" screws
.
NOTE: Feed the Air Control Rod into
the Air Control Slot on the Right Flashing before securing.
(FIGURE 1)
FIGURE 1
RIGHT
FLASHING
AIR
CONTROL
ROD
CONTROL
PANEL
LO
W
H
IG
H
1
2
3
4
5
AIR
CONTROL
SLOT
BURN
RATE LABEL
LO
W
H
IG
H
1
2
3
4
5
1
1
/
2
”
TOP
FLASHING
FIGURE 3
FIGURE 2
PUSH T
O
ST
ART / POUSSEE POUR COMMENCER
W385-0355
5
3
1
2
4
OPTIMUM
W
1
3
5
4
2
SHIPPING
BRACKET
SECURING
SCREWS
CONTROL
PANEL
SECURING
SCREWS
AK8 INSTALLATION
2.
Twist spring handle (supplied with the heater) onto the air
control rod until it hits the stop.
3.
Remove the two control panel securing screws, discard the
screws and shipping bracket.
(FIGURE 2)
4.
Secure the control panel to the
Right Flashing
using the two
#8 x 3/8" screws
.
(FIGURE 2)
Secure the
Left Flashing
with the
remaining
#8 x 1/2" screws
.
5.
Align the holes in
the top of the
Right
and
Left Flashing
with those on the
bottom lip of the
Top
Flashing
and secure
from the rear using
the four
#8-32 x 3/8"
screws
,
washers
and
nuts
.
(FIGURE 3)
6.
Affi x the burn rate
label under the slots
on the right fl ashing 1 1/2" in from the inside edge, with the word
"LOW" to the left.
(FIGURE 1)
Shown with AK8 and GICSK installed
1
2
4
3
5
4
3
2
1
LOW
HIGH
GICSK INSTALLATION
Refer to steps #11 and #12, as well as all warnings, in the
instructions included with your GICSK kit for installation.
NOTE: Affi x the logo to the bottom left hand corner
of the left fl ashing after the GICSK has been installed.
