Technisches Handbuch
SMCI12
Connections and circuits
3
Connections and circuits
3.1 Inputs and outputs: connector X11
Introduction
An overview of the assignments can be found in the connection diagram in Section
2.1. This section looks in detail at the assignment, functions and circuits of the
connector X11.
Pin assignment
Pin no.
Name
Observations
1
GND
Mass (0 V)
2 Input
1
3 Input
2
4 Input
3
5 Input
4
6 Input
5
7 Input
6
Digital inputs (max. 5 V)
8
Analog In
Analog input (–10 V ... +10 V)
9 Output
1
10 Output
2
11 Output
3
Digital outputs
12
GND
Mass (0 V)
Function of the inputs
All digital inputs – with the exception of the "Clock" input in the clock directional mode
– can be freely programmed using the NanoPro software (e.g. as a limit position
switch, enable, etc.) and can be used for sequential control with NanoJ.
All inputs can be configured for “active-high" (PNP) or “active-low" (NPN) with
NanoPro.
12
Issue: V 1.0
