Nanosurf easyScan 2 AFM, Operating Instructions Manual

Page: 154 / 164

S
TORING MEASUREMENTS AND FURTHER DATA PROCESSING
154
IMPORTANT
• After a fresh installation of the Report software, the Report software has
to have run at least one time before you can automatically start it from
the easyScan 2 software. To run the Report software for the first time,
select it from the MS Windows ‘Start’ menu.
• If you do not save the measurement in the easyScan 2 software, but only
save the report, the data in measurement channels that were not displayed
is lost.
• A measurement document should only display those channels that are
used in a template. When a template is applied to a measurement docu-
ment that displays different, or a different number of measurement chan-
nels than the template uses, the results may not be correct.
The Report generator configuration dialog is used to configure the behav-
iour of the Navigator Icon and the Report menu. For an in depth introduc-
tion to the Nanosurf Report software, refer to the Introduction section of
the Nanosurf Report on-line help.
The Report Menu
New Report
An empty report is opened.
Add Measurement
The currently active measurement is added to the currently opened report.
Apply Template...
Opens a dialog that allows you to select a template that is applied to the
currently active measurement.
Template list
The template list is a list of the templates that are stored in the template
directory (section
The Report generator configuration dialog (p.155)). Select-
ing a template applies this template to the currently active measurement.