Maintenance
Lubrication circuit
Draining the engine oil
I
Attention! :
Carry out these operations with the engine
stopped. Hot oil and hot surfaces can burn.
The oil is drained via the drain ori
fi
ce using the drain pump,
with the oil slightly warm.
• Start the engine and let it warm up for approximately 5
minutes so that oil suction is easier.
• Stop the engine. Remove the plug of the drain ori
fi
ce
A
.
• Connect the drain pump to the ori
fi
ce
A
. Use a pail to
collect the extracted oil.
• Pump until the oil has been completely extracted. Re
fi
ll
with the new oil (the amount of oil to add is indicated in
the technical speci
fi
cations section).
• Check the level with the gauge, ensuring you do not go
above the maximum level.
• Start the engine and check that the oil pressure indicator
is extinguished and that there are no leaks in the
lubrication circuit. Let the engine warm up for several
minutes and then check the oil level again. Fill again if
necessary.
• Re
fi
t the cap of the drain ori
fi
ce
19
A
