1.After receiving the light ,please check if any damage caused by transportation. If
there
is
damage caused by
transportation ,please do not use the light and contact with the distributor or the manufacturer
ASAP.
2.Please do not mount the light directly on the surface of the common combustible material.
Keep the light dry
and keep it away
from wet ,hot or dusty
condition ,prevent the light from water or other liquids.
3.Before installation ,please make sure the power voltage you use
should
be
according
to
the voltage
indicated
on the lamp ,please do not open and repair the lamp yourself when the power is on.
4.Please do not use the power cord which
is with
bad insulating layer, and do not pull the plug or drag the power
cord directly.
DMX IN
DMX OUT
The connection between light and light
,
or
between
light
and
the controller
should
use 3 pins power
cord which
the diameter
is not less than 0.5mm.Please use 3 pins XLR plug to connect the
DMX 512
output / input. The connection between XLR plug and the cable is showed as above
photo.
Use the XLR cable from the DMX output socket
of the controller to connect with the DMX input socket
of the
first light, and from the DMX output of the first lamp to connect with the DMX input of the second
lamp, and so on, until finish the connection of all lights.
·
Notice: the length of the XLR control cable can
'
t
be
longer than 300m.
CN
-
1200DCHS
Studio
LED
Light
Instruction
Sheet
The
lighting
comes
with
accessoiries
together
,
pls
check
carefully
.
Name
XLR
Signal
line
Instruction
sheet
Power
Adapter
Filter
set
Power
cable
Quantity
1
Unit
PC
Remarks
English
15V
Parameters:
LED
Bulbs
Amount:1200
pcs
Total
Power:72W
AC Power:100V-240V DC Power:15V
Color
Temperature:7500K-3200K
4.Channel instruction
When the LED light is mono color,the address choose 001,
it will occupy the corresponding pusher
CH1 in DMX
controller.
When the LED light is Bi-color,the address choose 001,and the system will occupy the corresponding
pusher CH1,CH2
in
DMX
controller
.
After choose and
confirm
the address
,
next
time
it
will
remain
the
previous
address
as
a
default
one
.
Safety Warning:
control signal
connection
General Breakdown
Service
Description of Breakdown
Measurements
The
lamp
can
not start up
normally
The manual function is right but can not
controlled by the controller
The screen can not display or the content disorder
The
light
is
on
but
can not be operated by
manual or controller
1
.
Please
check
if the power cord is connected firmly
2.The plug of the power supply is connected well with
the lamp or
not
1
.
Check
the setting of the DMX starting address is correct
or
not
2
.
Check
if
the
XCR signal wire damaged
or
not.
Turn
off
the
power
for
1
minute and restart.
Internal CPU chip damaged,please contact with the
supplier or return it back to factory.
GND 1
DATA- 2
DATA+ 3
1 GND
2 DATA-
3 DATA+
1
PC
1
PC
1
SET
1
PC
www.nglbg.com
Add:Zhanglin
Section,Highway324,Dongli,Chenghai,Shantou
City,Guangdong Province
,
China
Tel:+86-754-85751187
Fax:+86-754-85300887
E-mail:[email protected] http://www.nglbg.com
Please switch off
the power button
before inserting
or removing the
power cable.
Guangdong NanGuang Photo&Video Systems Co.,Ltd
