Page 33
4. MOVING THE MACHINE
This equipment is fitted with castors to make it easier to move. Take care when
moving the equipment on an inclined floor.
The overall height of this equipment is 2230mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
WARNING
NEVER turn the power to the machine ON until installation
has been completed.
WARNING
In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
WARNING
So that customers are not injured , ensure that there is at
least 500mm separation between other machines or walls.
CAUTION
In order to avoid damage to the machine due to mis-operation,
ensure that the voltage of the mains supply is 230volts AC.
5. INSTALLATION
Notes on Installation
NOTE
If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level adjusters
to prevent the machine sliding on the floor.
In order to gain access to the Power Supply and CPU assemblies,
make sure that the rear of the machine is separated from a wall
or other machine by at least 500mm.
When installation is complete, it is imperative that the guns are
Summary of Contents for Vampire Night DX
Page 3: ...Page 2...
Page 74: ...Page 73...
Page 81: ...Page 80 8 6 Gun Assembly 2 4 7 6 12 10 13 11 3 9 5 1 8...
