NAMCO Prop cycle, Operator'S Manual

Page: 18 / 59

Page 18
5-3-3-2 Pedal Test
a. Select “PEDAL” on the menu screen and press the start button. The
following screen is displayed.
I/O TEST
DIP 12345678
SWITCH
PEDAL
PEDAL 7FBF .................... (a)
READY
PRESS START .................... (b)
TO EXIT : PUSH START AND HANDLEBARS UP
}
(a) Pedal rotation When the pedals are rotated in the forward
direction the value increases, and when they
are rotated in the backward direction the value
decreases.
(b) Rotation sensor check This mode checks whether the sensor is
reading the pedal rotation correctly. (see
below)
b. When the start button is pressed, the following screen is displayed.
I/O TEST
DIP 12345678
SWITCH
PEDAL
PEDAL ACB7
NOW COUNTING
PEDAL IT 10 TIMES
THEN PRESS START
TO EXIT : PUSH START AND HANDLEBARS UP
c. When the above screen is displayed, pedal ten full turns in the
forward direction. Stop as soon as the pedal has been turned
exactly ten times.
d. Press the start button again.