NAMCO PAC-MAN SWIRL, Operation Manual

Page: 68 / 125

68
7. Troubleshooting
- Must be performed by a technician -
7-3-10 TABLE POSITION SENSOR/TABLE ORIGIN SENSOR
Core assembly (table)
TABLE POSITION SENSOR TABLE ORIGIN SENSOR
Pan head screw
(w/washers) (M3 x 12)
Pan head screw
(w/washers) (M3 x 12)
Hole
GUARD F
Station 2 (blue)
Remove the MAINT DOOR C on Stations 2 and 3 (blue and red) using the service key.
Loosen the two upper pan head screws with washers (M4 x 6) to remove the GUARD F.
Unscrew the pan head screws with washers (M5 x 12), unscrew the four pan head screws with
washers (M5 x 12), that secure the BALLSLOPE UNIT to the MIDDLE PLATE, and disconnect
the harness connectors to replace the BALLSLOPE UNIT on the left side.
Insert the screwdriver into the slot on the MIDDLE FRAME A, unscrew the pan head screw with
washers (M3 x 12), and disconnect the harness connector to replace the TABLE POSITION
SENSOR.
Insert the screwdriver into the slot on the MIDDLE FRAME A, unscrew the pan head screw
with washers (M3 x 12), and disconnect the harness connector to replace the TABLE ORIGIN
SENSOR.