A3LA-R User Guide Version A
Document Number: 451-93156-001A
81 of 158
+WDLDM: <dldm>,<mi>,<dtl>
Test Command:
+WDLDM=?
List the supported parameter settings. The response is in the form:
+WDLDM: (supported <dldm>s), (supported <mi>s), (supported <dtl>s)
B.84 +WDAV
–
R
EGISTER OR
D
EREGISTER AN
RS232
DAV
D
ATA
P
ERIPHERAL
Set Command:
+WDAV=[<DP type>[,<encrypt>]]
Register or deregister an RS232 DAV Data Peripheral (DP).
<DP type> can take on the following values:
0
Deregister peripheral
1
Register Type 1 RS232 DAV Data Peripheral
<encrypt> can take on the following values:
0
Encryption is not supported at this time
Read Command:
+WDAV?
Query the current DP registration parameter settings. The response is in the form:
+WDAV:<DP type>,<encrypt>
Test Command:
+WDAV=?
List the supported DP registration parameters. The response is in the form:
+WDAV:(supported <type>s),(supported <encrypt>s)
B.85 +SBDWB
–
S
HORT
B
URST
D
ATA
:
W
RITE
B
INARY
D
ATA
Exec Command:
+SBDWB=[<SBD message length>]
This command is used to transfer a binary SBD message from the DTE to the single
mobile originated buffer in the A3LA-R. The mobile originated buffer can contain only
one message at any one time.
Once the command is entered, the A3LA-R will indicate to the DTE that it is
prepared to receive the message by sending the ASCII encoded string
“READY<CR><LF>” (hex 52 45 41 44 59 0D 0A) to the DTE.
