A3LA-R-MIL-MOD User Guide Version B
Document Number: 451-93156-001A
40 of 159
B.14 &M
N
–
A
SYNCHRONOUS
/S
YNCHRONOUS
M
ODE
Select the DTR operating mode.
0
Selects normal asynchronous operation (default). (See &Qn)
B.15 &Q
N
–
S
YNC
/A
SYNC
M
ODE
Select asynchronous mode. This is an extension of the &M command and is used to
control the connection modes permitted.
Note: The register is not updated right after the user requests new values because the
requested values may or may not be what IRLP will use once a data call is established
due to negotiations with the other peer. If the register is updated right away, this may
give the user the impression that those values will be used during the data call, but
there is no guarantee that will be the case. The real values will only be known once a
data call is established and the negotiation phase is done. For that reason, the values
are written to the register only after a call is established and both sides have
negotiated parameter values (such as mode of operation). The value of the register
will be reset to default value (5) after the call completed.
0, 6
Normal
asynchronous
operation
with
no
error
correction
(unacknowledged mode)
5
Asynchronous operation with error correction (acknowledged mode)
(default)
B.16 &S
N
–
DSR
O
VERRIDE
Define the behavior of DSR.
0
DSR always active (default)
1
Same as 0
B.17 &V
–
V
IEW
A
CTIVE AND
S
TORED
C
ONFIGURATION
View the current active configuration and stored profiles.
