Matsushita Electric Works Fire & Security Technology AB
MEW00442
Rev: -
Operating Instructions EBL512, V1.44.x
89
27.9
Select unit on COM-loop to use for
triggering (H5/A8)
This function is used by service engineer and by R&D for
troubleshooting.
On the pin respectively you will get a pulse to trig an oscilloscope etc.
COM loop
Main board 1556, JP2, "upper" pin: Each unit not giving a correct
answer.
Main board 1556, JP2, "lower" pin: When a specific unit is being
polled.
BS4 loop
Autronica interface board 1584, BY3, "left" pin: When a specific unit
is being polled.
Autronica interface board 1584, BY3, "right" pin: 0 V.
(BS4 board = Autronica interface board 1584)
Action
Text in display
Comments
"Access"
According to chapter
"Access code for
programming (H5)", see
page 81.
Scroll to menu A8
Select unit on COM-loop to use for
trigging ACCEPT? A8
"A"
Select type of loop: 0
(0=COM, 1=BS4) ACCEPT?
Select type of loop. Push
"A" to accept.
CU: 00 Loop: 0 Address: 000
ACCEPT?
"A"
or
"1", "A"
CU 00, BS4-Board 0, Loop: 0,
Address: 00 ACCEPT?
Write control unit number,
(board number; 0-3), loop
number and address. Push
"A" to accept.
"A"
Select type of loop: 0
(0=COM, 1=BS4) ACCEPT?
Select type of loop. Push
"A" to accept or push
"Return" to menu A8..
"Return"
Select unit on COM-loop to use for
trigging ACCEPT? A8
Scroll or push "Return" to
H5. Scroll or push
"Return" to logout.
