Matsushita Electric Works Fire & Security Technology AB
MEW00442
Rev: -
Operating Instructions EBL512, V1.44.x
99
30.5
Acknowledge SERVICE signal (H8/S4)
See chapter "Sensors activating SERVICE signal (H4/U7)", page 77.
When service signal from a sensor is acknowledged, the sensor is
given a default sensor value (for a new / clean sensor), i.e.
first
replace the sensor,
then
acknowledge the service signal.
NOTE!
If a sensor is replaced without activating service signal, it has
to be reset to the default sensor value. See chapter "Reset of a sensor
week average value", page 75.
Action
Text in display
Comments
"Access"
According to chapter
"Access code for
maintenance", see page 95.
Scroll to menu S4.
Acknowledge SERVICE signal
ACCEPT? S4
"A"
Sensor : xxxxxx needs service
L
If there are no sensors to
acknowledge, menu S4
will be shown again.
If it's the correct sensor to
acknowledge, push "Fault
acknowledge" and you will
return to menu S4.
If not, scroll or write the
wanted sensor and push "
Fault acknowledge" and
you will return to menu S4
or
push "Return" to S4.
"Fault acknowledge"
The service signal for that sensor is now acknowledged and
the next sensor will be shown in the display.
Sensor : xxxxxx needs service
L
If more service signal
acknowledgements shall
be done, continue like
above. If not, push
"Return" to menu S4.
"Return"
Acknowledge SERVICE signal
ACCEPT? S4
Scroll or push "Return" to
menu H8. Scroll or push
"Return" to logout.
