13
n-SATS
9.3 n-STAND Construction
Naim Floor Protectors can be
used to if the n-STAND is to be
installed on a non-carpeted floor.
Use the supplied allen key to
adjust each floor spike from the
top. Tighten the lock-nuts once
the stand is level.
floor spike
adjustment
protector
n-SATS Specification
Frequency Response:
50Hz - 20kHz
Sensitivity:
87dB/1W/1m
Power Handling:
100 Watts (music programme)
Impedance:
6
Ω
(nominal)
Dimensions (H x W x D):
285 x 200 x 208mm
Weight (unpacked):
5.5kg
Finishes:
Cherry, Maple, Black Lacquer
Attach the base to the upright
using the four small cap-head
screws and the supplied allen
9.4 n-STAND Installation
Remove the two button-head
screws and replace them with
cap-head screws and mounting
lugs.
Lower the n-SATS speaker on
to the n-STAND cradle and
adjust to sit vertically with the
central grub screw.
Route the speaker cable
up the stand upright and
dress with the dressing
pins.
Note:
Dressing the cables
too tightly in the stand
upright may degrade the
n-SATS performance.
Leave some slack -
especially between the
speaker terminals and the
first dressing pin. A small
improvement in n-SATS
subjective performance
may be perceived by
leaving the loudspeaker
cables undressed.
