HIGH VOLTAGE
TERMINAL BLOCK
RESETABLE
FUSE
MAIN POWER
SWITCH
TRANSFORMER
CONTROL
BOARD
Page 8 of 24
9/18 IOM-FFDINST
Nailor Industries Inc. reserves the right to change any information concerning product or specification without notice or obligation.
ACCESS TO ELECTRICAL COMPONENTS
WARNING!
Disconnect the unit from the electrical power source before attempting to service the unit.
Step 1
Turn off the unit with the switch located on the electrical box.
Step 2
Disconnect the unit at the power source or at the service panel in accordance with OSHA (LOTO) practices and
procedures.
Step 3
Use a 5/16" (10) hex driver to remove screws holding electrical access panel. Swing panel up to release from the
tabs.
Step 4
To remove transformer:
Step 4a
Disconnect all wires from terminals. See wiring diagram for replacing wires.
Step 4b
Using a 1/8" (3) drill bit, drill out the two rivets. Clean debris.
Step 4c
Use new 1/8" (3) rivets or # 6 screws to install replacement transformer.
Step 5
To remove control board:
Step 5a
Using a 1/8" (3) drill bit, drill out the two rivets holding the control board to the electrical box. Clean debris.
Step 5b
Remove the two red plugs and use a small screwdriver to remove power wires.
Step 5c
Use new 1/8" (3) rivets or # 6 screws to install replacement board.
Step 6
Reverse above steps to replace electrical components and to replace panel.
