MULTISTATION 1000
UPS 1000VA
Ver.00
12 Maggio 2016
5
3.
INSTALLATION
3.1 Unpacking and verification
Unpack the UPS. When op
ening the box, if UPS is damaged or dented don’t connect it to electrical
network. Please call your reseller for product’s replacement.
3.2 Posizionamento
1. Install the UPS in an environment that is free of excessive dust, corrosive gas and conductive contaminants.
Don’t use the UPS in environments where temperature and/or humidity are too high.
2. UPS must be positioned where there is adequate air circulation around the unit.
3. To place the UPS at least 20cm far from any monitor or screen in order to avoid interference.
3.3 Battery recharge
The unit is shipped from the factory with a fully charged internal battery, however, it could be discharged
during transportation, so it has to be recharged before use. To do this, connect the unit to an appropriate
power outlet and let the battery recharge for at least 6 hours without any load connected.
.
3.4 Connection
Connect the power cord to an earthed power outlet
(5), then connect your computer and its devices to the
UPS protected outlet
(7) or to the other outlets (non-protected) (6).
IMPORTANT
:
The total power consumption of the load must not exceed the maximum power rating of
the UPS, specified on UPS label.
