Deluxe Double Chair/Rocker
Congratulations on your purchase. You now have one of
Nags Head Hammocks’ innovative products! If you have any
questions regarding this product, we invite you to call us 7
days a week at 800-344-6433.
Helpful tips before starting: • Get someone to help you. Some
pieces are heavy and a second pair of hands always helps. •
Do not tighten the bolts completely until the product is fully
assembled. Some pieces are harder to fi t in place and this will
help. A hammer or rubber mallet is needed during assembly.
• Do not over-tighten the bolts or screws. • Build your item
close to where it will be used to eliminate difficulty in moving
once completed. • For a uniform look, face all nuts in the same
direction.
Chair/Rocker
Chair
Double Rocker includes this
additional hardware:
2 - 5” x .25” Hex Bolts
4 - 3.5” x .25” Hex Bolts
12 - .25” Washers
6
- .25” Lock Nuts
Double Chair
7 - 5” x .25” Hex Bolts
8 - 3.5” x .25” Hex Bolts
30 - .25” Washers
15 - .25” Lock Nuts
6 - 4.5” x .25” Button Head Cap
8 - .75” Barrel Bolt Assemblies
2 - 4”x.25” Button Head Cap
1 - Allen Wrench
Hardware
Rocker
Additional Parts For Rocker
Parts:
Item# NHDWDC
Item# NHDWDR
1. Align left arm with chair body. Large hole for cupholder should be
at front of arm and aligned with holes at front of rollup. Insert 3.5” hex
bolt through washer, through arm and chair body. Secure using washer
and nut. FIGURE 1. Use this same process for 2 holes on front leg, lower
hole on back leg.
2. Repeat Step 1 for right arm.
3. Lay upper body rollup to front of swing as shown. FIGURE 2
FIGURE 1
FIGURE 2
Chair Roll-up
Front Center Legs
Rear CenterLegs
Table Top
Left Arm
Right Arm
L
eft Upright
Right Upright
C
ent
er Upright
Cup
Holders
Runners
Barrel Bolts 4 1/2” and 4” (
with Button Head Caps)
Hex Bolts 5” and 3 1/2”
Previously attached hex bolts
Front of rollup
Left Arm
Right Arm
Front Center Legs
Rear Center Legs
Center runner
Left runner
Right runner
Bottom
hole
