7
Locate the 3 holes for the feed. Put the cones in place, fit the little rubber feet and lock the
assembly using the 3 screws. (Allen key 2.5)
Vertical position:
Turn the MPA upside down.
Locate the four screws that need to be removed
(Allen key 2.5).
Put the two long feet in place and lock them with
the four Allen screws provided.
CONNECTING THE MPA TO THE SOURCE PREAMPLIFIER
Connect the source preamplifier to the 3-pole XLR balanced input connectors left and right
channel (“A” if no RCMI option) on the rear panel of the MPA. If necessary, use the XLR/RCA
adapter connector supplied to connect an unbalanced RCA lead to the XLR connector.
CONNECTING THE LOUDSPEAKERS
On the rear of the MPA stereo block there are two pairs of gold plated loudspeaker terminals.
The loudspeaker cables should be connected as shown below.
RIGHT SPEAKER
LEFT SPEAKER
