S3600 Series Installation Guide
Installation Guide
NADDOD Pte. Ltd.
12
Figure 2-5 Schematic Diagram of Foot Pad Installation
2.2.4 Installation and Disassembling of Power Module
Installation Procedure
The power module of S3600 series switches support hot plug, and the installation procedure is
as below:
Step 1:
Wear anti-electrostatic wrist, and confirm the anti-electrostatic wrist is grounded properly.
Step 2:
Figure out the correct directions of power supply (otherwise it is unable to install the power
supply onto the base in a safe way).
Step 3:
Hold the handle of power module with one hand, hold the bottom of power module with
another hand, and push in the power module smoothly along the power supply socket until
the power module completely connects with the underpan.
Step 4:
Fix the power supply onto the switch via the power fixing device.
Figure 2-6 Schematic Diagram of Power Module Installation
Description:
(1): power module handle
(2): power module fixing device
Disassembling Procedure
The power module of S3600 series switches support hot plug, and the disassembling
procedure is as below:
Step 1:
Wear anti-electrostatic wrist, and confirm the anti-electrostatic wrist is grounded properly.
Step 2:
Disconnect the power supply of switch.
Step 3:
Hold power module handle and press the fixing device with one hand, and press the switch
with another hand.
Step 4:
Pull out the power module smoothly along the power supply socket.
Figure 2-7 Schematic Diagram of Power Module Disassembling
