S3600 Series Installation Guide
Installation Guide
NADDOD Pte. Ltd.
9
NOTE
The switches of this series come without installation tools, which must be prepared by users.
2.2 Installation
S3600 series switches can be installed in two ways:
Installing by fixing the front suspension loop and chassis tray.
Installing on the table.
2.2.1 Suspension Loop Description
Figure 2-1 Schematic Diagram of Front Suspension Loop
Description:
(1): Screw hole for fixing the front suspension hoop and chassis
(2): Screw hole for fixing the front suspension hoop and switch
CAUTION
The front suspension loop is for fixing switches only, and cannot be used for load-bearing.
2.2.2 Installing by Fixing the Front Suspension Loop onto the
Chassis via Chassis Tray
Installation Steps
Step 1:
Take on anti-electrostatic wrist, and check the grounding and stability of chassis.
Step 2:
Horizontally fix the tray of the chassis in a proper position of the chassis.
